Zinc Alloys were developed specifically for pressure die casting using hot chamber casting, which is highly automated and the most popular and efficient die casting process. ZA Alloys (Zinc Aluminum Alloys) were developed initially for gravity casting using sand, permanent mold, plaster mold and graphite mold casting techniques. ZA alloys can be used in pressure die casting, but require a cold chamber casting method. Only ZA-8 can be hot chamber die cast. Safety Data Sheet available upon Request
Unit of Measure
Advantages
|
Ingredients of Material - Zinc
|
Ingredients of Material - Aluminium
|
Hazards Identification
Advantages
N/A
• Can produce parts of almost any shape. |
Ingredients of Material - Zinc
Hazardous Ingredients |
N/A Zinc |
Approx. Concentration |
N/A 87 - 89 % |
C.A.S.N.A. or U.N. Numbers |
N/A 7440-66-6 |
Exposure Limits |
N/A 15.0 mg/cu.m 5.0 mg/cu.m ACGIH TLV-TWA |
Ingredients of Material - Aluminium
Hazardous Ingredients |
N/A Aluminum |
Approx. Concentration |
N/A 11 - 13 % |
C.A.S.N.A. or U.N. Numbers |
N/A 7429-90-5 |
Exposure Limits |
N/A 15.0 mg/cu.m |
Hazards Identification
Skin / Eyes |
N/A Remove contaminated clothing. Wash affected areas with soap andwater.Flush eyes with luke warm gently running water. If irritationpersists, consult physician. |
Inhalation |
N/A If exposed to excessive fume, remove to fresh air; administeroxygen if needed. Keep patient warm and seek medical assistance. |
Ingestion |
N/A Generally not considered toxic if ingested however, consult physicianimmediately. |
General Advise |
N/A Practice good personal hygiene. Wash hands before eating orsmoking. |